Tweet
The rollers inside the bottom of my sliding glass door have become worn out. I have taken the door out/off the track and looked at them. It's obvious to me that the rollers are bad. But I don't know how to replace them. There is a screw that is inside a hole on the two sides of the door down near the rollers. There is also a screw protruding from the two sides just above the holes I just mentioned. Can anyone describe how to replace the rollers?
-
-
Not all rollers are removed the same. Some are held in with a screw and some are just pressure fit and are pryed out. Below is a link that will show both ways, hope this helps
http://www.prime-line-products.com/howtoslide4.asp -
One of the screws are the installation screw and the other is an adjusting screw.
Here is a link to an article on how to replace patio glass door rollers:
Comment
Comment