I just joined in since I am undertaking cleaning and painting my fireplace while my husband is out of town. I went to Home Depot and they recommended cleaning the soot with a biodgradable cleaner called Simple Green. A little smelly but cleans really well. I used a wire brush to scrape away the tougher parts. You spray it on full strength, then scrub with the wire brush and then rinse with water. Wait 10 min. between applications and do this about 3 times. To back up, I prepped the area by shoveling the ash out and then vaccumming with a shop vac the rest of the loose soot - the walls and floor area. Now I'm ready to begin painting. I was advised that I could paint directly on the brick or prepare the surface with a good latex primer like Zinzer. Then use any paint you cbose - flat or gloss. I was planning to use the same paint as I did on the wood trim and mantle (the glossy paint will clean better). I was only going to paint the front facing and the brick on the floor in front of the fireplace. I don't think I'll paint the red brick along the inside from framing of the fireplace due to heat from the fire. I was told that if the brick does not get beyond 200 degrees, then you really do not need to use a masonry paint. Any other suggestions? I'm planning on tackling the painting tomorrow.
![Smile](https://homerepairforum.com/core/images/smilies/smile.png)
Comment