Tweet
Help wiring RF receiver to garade door controller
I need help with wiring an RF receiver to my garage door.
The garage door is currently being opened/closed by a 3-state switch that you can see in the image below:
This switch is connected to the motor like this:
The bottom 3 cables are the ones connected with the switch. The top right cables go to the power source and the top left cables are from the motor.
On top of this configuration, I wish to connect my 2-channel transmitter. I bought a Towitek RF receiver (google "TowiTek 2 channel radio-switching system") Could you help me connect it to the current setup? I am an amateur with electricity, so it would benefit most from a stupid explanation of which wire color goes where or maybe a small diagram.
Thank you for taking the time to read my question.
The garage door is currently being opened/closed by a 3-state switch that you can see in the image below:
On top of this configuration, I wish to connect my 2-channel transmitter. I bought a Towitek RF receiver (google "TowiTek 2 channel radio-switching system") Could you help me connect it to the current setup? I am an amateur with electricity, so it would benefit most from a stupid explanation of which wire color goes where or maybe a small diagram.
Thank you for taking the time to read my question.