Grumpy
New Member
Last Activity: Yesterday, 08:33 AM
Joined: 01-25-2021
Location:
-
i have 1 factory burn mat left but have thought I would look for something from McMaster-Carr to be more economical. I was wondering about gluing under... -
I decided to go back through everything to see if I could find something I missed or that didn't look right, It all looked good to me except the burn...Leave a comment:
-
I am going to pull the flue pipe out tomorrow and check it very close. It has a coating of soot in it now. I did see the damper in the air hose when I...Leave a comment:
-
Thanks Hawkins, I really appreciate your response. I know the damper can be adjusted by loosening the 2 screws at the rear and the damper can slide up...Leave a comment:
-
I dont think there is a damper in the air hose. There is one in the combustion fan housing. I put new bearings on the combustion fan motor, replaced the...Leave a comment:
-
Monitor 41- Flame issues
I have a 41 that I just rebuilt the combustion chamber on. New burn pot and ring and new gaskets. Looks to be burning fine on low but when it ramps up...
No activity results to display
Leave a comment: