Bodrey
New Member
Last Activity: 02-13-2025, 05:02 PM
Joined: 08-03-2023
Location:
-
DONE!!! I finished re-wiring the entire circuit and re-installed the GFCI today. Of course, I tested it before putting everything back and it's all good.... -
I think I discovered the reason for the 75V reading. I opened the junction box under the vanity today. The cable that runs from the panel to the junction...Leave a comment:
-
There's a junction box located behind my bathroom sink. I'll check the connections (in particular the ground to make sure it's secure). However, I'm not...Leave a comment:
-
I tested the wiring using an analog multimeter and this is what I found:
- Voltage between the hot and neutral wires was within normal range...Leave a comment:
-
My particular GFCI doesn't have back stab connectors. Instead, it has something called back wire clamps. You insert the bare wire behind it and then tighten...Leave a comment:
-
Machinist,
I've got the GFCI wired as per your instructions. When I plug in the GFCI tester it (technically?) indicates that it's wired correctly....Leave a comment:
-
Hello All,
After a long break, I'm back with an update...
I never did figure out the cause of the wiring fault and I was just...Leave a comment:
No activity results to display
Leave a comment: