It just stopped workings. It is an older unit. I read through the forum some and checked a few things. The element tests OK(10ohms). Then I got to the thermostats and high limit switch. I had a question about these. The the two thermostats(2) and the high limit(1) are marked on the picture where they are located. The two thermostats(2) have continuity, but the high limit(1) is open. Is this how they are suppose to be? If so, what should I look at checking next?
Announcement
Collapse
No announcement yet.
Kenmore Dryer does not heat
Collapse
Forum Top GA Ad Widget
Collapse
X
Comment