I have a 40' x 48' shop about 16' high. Steel building & well insulated. Am planning on using tube heat hung from ceiling. Can I run 1 tube intake in front and exit out rear? Or is there a preferred method?
-
-
are we talking quartz tube type heater -
propane furnace & 5" tube close to ceiling. In the front & out the back or u-shape that would be in & out front of buildingComment
-
check the cfm output of the furnace blower. I would assume a 10 inch round duct with registers every 6 feet the length of it. end would be capped. makeup air goes through a filter at the furnace location.Comment
-
Heat
try this diagram, see what you thinkComment
-
Has anyone had an occurrence of a Laser 730 or 731 over firing?
The top of the heat chamber and the heat exchanger glow red on high when this occurs....
Comment